Cisco ONS 15454 Series Procedure Manual page 173

Chapter 1 Install the Cisco ONS 15454 Shelf Assembly
Step 7 Enter the following interface commands:
(Switch(config)#interface GigabitEthernet0/1
(Switch(config)#no ip address
(Switch(config)#ip http server
(Switch(config)#interface GigabitEthernet0/2
(Switch(config)#no ip address
(Switch(config)#ip http server
(Switch(config)#interface Vlan public VLAN ID
(Switch(config)#no ip address
(Switch(config)#no ip route-cache
(Switch(config)#ip http server
Enter the following commands to configure authentication:
Step 8
Switch(config)#line con 0
Switch(config)#line vty 0 4
Switch(config-line)#password yyyyyy
Switch(config-line)#login
Switch(config-line)#line vty 5 15
Switch(config-line)#password yyyyyy
Switch(config-line)#login
Switch(config-line)#end
Stop. You have completed this procedure.
NTP-G304 Configure the MS-ISC-100T Card for a ONS 15454
Multishelf Node for Non-Default Public and Private VLAN IDs
Purpose
Tools/Equipment
Prerequisite Procedures Applicable procedures in
Required/As Needed
Onsite/Remote
Security Level
At the Cisco IOS command line interface (CLI) for the MS-ISC-100T card, enter the following spanning
Step 1
tree commands:
Router(config)# bridge public VLAN ID protocol rstp
Router(config)# bridge public VLAN ID forward-time 5
Router(config)# bridge public VLAN ID max-age 10
Router(config)# bridge private VLAN ID protocol rstp
Router(config)# bridge private VLAN ID forward-time 5
Router(config)# bridge private VLAN ID max-age 10
Step 2 Enter the following commands to configure the ports DCN 1 and DCN 2:
78-19286-01
Use this procedure to configure the MS-ISC-100T Card for a multi-shelf
node for non-default public and private VLAN IDs.
Voltmeter
Assembly"
Required
Onsite
None
Cisco ONS 15454 DWDM Procedure Guide, Release 9.2
Required Tools and Equipment (ETSI)
Chapter 1, "Install the Cisco ONS 15454 Shelf
1-85