Cisco ONS 15454 Series Procedure Manual page 92

Required Tools and Equipment (ANSI)
•
•
•
•
•
•
•
•
•
•
User-Supplied Materials (ANSI)
The following materials and tools are required but are not supplied with the ONS 15454 ANSI:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Cisco ONS 15454 DWDM Procedure Guide, Release 9.2
1-4
#12 -24 x 3/4 socket set screws (48-1003-XX) (2)
T-handle #12-24 hex tool for set screws (1)
ESD wrist strap with 1.8 m (6 ft) coil cable (1)
Tie wraps (10)
Pinned hex (Allen) key for front door (1)
Spacers (50-1193-XX) (4)
Spacer mounting brackets (2)
Sheet metal backplane cover (installed) (1)
External (bottom) brackets for the fan-tray air filter
Standoff kit (53-0795-XX):
– Plastic fiber management guides (2)
Fan filter bracket screws (53-48-0003) (6)
–
One or more of the following equipment racks:
19-inch ANSI Standard (Telcordia GR-63-CORE) (482.6 mm) rack; total width 22 inches
–
(558.8 mm)
23-inch ANSI Standard (Telcordia GR-63-CORE) (584.2 mm) rack; total width 26 inches
–
(660.4 mm)
Fuse panel
Power cable (from fuse and alarm panel to assembly), #10 AWG, copper conductors,
194 degrees Fahrenheit (90 degrees Celsius)
Ground cable #6 AWG stranded
Alarm cable pairs for all alarm connections, #22 or #24 AWG (0.51 mm² or 0.64 mm²), solid tinned
100-ohm shielded building integrated timing supply (BITS) clock cable pair #22 or #24 AWG
(0.51 mm² or 0.64 mm²), twisted-pair T1-type
Single-mode SC fiber jumpers with UPC polish (55 dB or better) for optical (OC-N) cards
Shielded coaxial cable terminated with SMB or BNC connectors for DS-3 cards
Shielded ABAM cable terminated with AMP Champ connectors or unterminated for DS1N-14 cards
with #22 or #24 AWG (0.51 mm² or 0.64 mm²) ground wire (typically about two ft [61 cm] in length)
6-pair #29 AWG double-shielded cable
Tie wraps and/or lacing cord
Labels
CLETOP cleaning cassette
Listed pressure terminal connectors such as ring and fork types; connectors must be suitable for
#10 AWG copper conductors
Chapter 1 Install the Cisco ONS 15454 Shelf Assembly
78-19286-01