Cisco ONS 15454 Series Procedure Manual page 141

Chapter 1 Install the Cisco ONS 15454 Shelf Assembly
DLP-G22 Install LAN Wires on the MIC-C/T/P (ETSI Only)
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Rather than using the LAN connection port on the MIC-C/T/P, you can use the LAN connection port on
Note
the TCC2/TCC2P/TCC3 card if preferred. Use either the MIC-C/T/P connection or the
TCC2/TCC2P/TCC3 card connection. You cannot use the LAN connection port on the MIC-C/T/P and
the LAN connection port on the TCC2/TCC2P/TCC3 card simultaneously; however, it is possible for
you to make a direct connection from a computer to the LAN connection port on the
TCC2/TCC2P/TCC3 card while the LAN connection port on the MIC-C/T/P is in use as long as the
computer connected directly to the TCC2/TCC2P/TCC3 card is not connected to the same LAN.
Using 0.51 mm² or 0.64 mm² (#22 or #24 AWG) wire or CAT-5 Ethernet cable, connect the wires to the
Step 1
RJ-45 connector according to
Table 1-5
LAN
LAN 1
Connecting to DCE
(a hub or switch)
Cross-over Ethernet cable
78-19286-01
This task installs the LAN wires on the ONS 15454 ETSI MIC-C/T/P.
Standard CAT-5 Ethernet cable (straight-through for data terminating
equipment [DTE] or cross-over for data circuit-terminating equipment
[DCE])
or
RJ-45 connector
Crimping tool for RJ-45 connector
0.51 mm² or 0.64 mm² (#22 or #24 AWG) wire, preferably CAT-5
NTP-G6 Install the MIC-A/P and MIC-T/C/P FMECs (ETSI Only),
page 1-31
As needed
Onsite
None
Table 1-5.
LAN Pin Assignments
RJ-45 Pin
1
1
2
3
4
5
6
7
8
Required Tools and Equipment (ETSI)
RJ-45 Pin
3
6
1
4
5
2
7
8
Cisco ONS 15454 DWDM Procedure Guide, Release 9.2
Function
PNMSRX+
white/green
PNMSRX–
green
PNMSTX
white/orange
—
—
PNMSTX–
orange
—
—
1-53