Cisco ONS 15454 Series Procedure Manual page 136

Required Tools and Equipment (ETSI)
Table 1-2
AEP Cable Wire
Black
White
Slate
Violet
Blue
Green
Yellow
Orange
Red
Brown
Step 6 Continue with the
procedure on page
Stop. You have completed this procedure.
NTP-G10 Attach Wires to Alarm, Timing, LAN, and Craft Pin
Connections
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Cisco ONS 15454 DWDM Procedure Guide, Release 9.2
1-48
Pin Assignments for the AEP
Backplane Pin AIC-I Signal
A1 GND
A2 AE_+5
A3 VBAT–
A4 VB+
A5 AE_CLK_P
A6 AE_CLK_N
A7 AE_DIN_P
A8 AE_DIN_N
A9 AE_DOUT_P
A10 AE_DOUT_N
"NTP-G10 Attach Wires to Alarm, Timing, LAN, and Craft Pin Connections"
1-48.
This procedure installs alarm, timing, LAN, and craft wires on the
ONS 15454 shelf. These wires are attached to the mechanical interface card
(MIC) FMECs on the ETSI shelf and are attached to the backplane on the
ANSI shelf.
Connectors according to function
Twisted #22 or #24 AWG (0.51 mm² or 0.64 mm²) shielded wires for LAN
or craft
75-ohm coaxial cable with 1.0/2.3 miniature coax connector
0.51 mm² or 0.64 mm² (#22 or #24 AWG) alarm wires
NTP-G6 Install the MIC-A/P and MIC-T/C/P FMECs (ETSI Only),
page 1-31
NTP-G5 Remove the Backplane Covers (ANSI Only), page 1-29
As needed
Onsite
None
Chapter 1 Install the Cisco ONS 15454 Shelf Assembly
AEP Signal
AEP_GND
AEP_+5
VBAT–
VB+
AE_CLK_P
AE_CLK_N
AE_DOUT_P
AE_DOUT_N
AE_DIN_P
AE_DIN_N
78-19286-01