Table of Contents
Advertisement
Chapter 5 Web GUI Setup and Monitoring
Configuring Transport Stream Information
Configuring the ASI Output
1
From the user interface of the D9859, choose Transport Stream > ASI Output.
The ASI Outputs page is displayed.
Note: After you make any changes, a successfully updated (session open)
message appears. The changes are displayed, but not saved. You must click
Apply to save and apply the changes.
Note: Any changes made to the ASI DPM values will automatically change the
Mode Status to Edited by User.
2
From the Rate Control drop-down list, choose the output rate control. The
following table describes the affect each of the settings has on the output bit rate:
Rate Control
Auto
182
Description
The output rate follows that set by the uplink. The output rate will
be the same as the input rate (including all null packets). This
means the output bit rate is determined automatically based on
the input source symbol rate and FEC value.
OL-31980-01
Hide quick links:
Advertisement
Table of Contents
