Cisco D9859 Installation And Configuration Manual page 214

Chapter 5 Web GUI Setup and Monitoring
Action
Drop
Map
11 In the Stream Type field, enter a stream type to map within a PE to a specified
PID (0 to 255).
12 From the Category drop-down list, choose the service to configure. If an input
service matches this type and Instance, then the Action will be applied. This
value is only used if the Action is set to Map. The categories are: UNKN, CDT,
LSDT, DATA, TTX, MPE, DPI, VBI, SUBT, AUD, VID, PCR or INVL.
13 In the Instance field, enter the instance of the service specified by Category to
configure (1 to 64). If an input service matches this type and instance, then the
Action will be applied.
14 If Action is set to Map, enter the Output PID number (0 to 8192).
15 Click Save.
16 Click OK.
To remove a PID mapping, select the entry you want to remove and click Delete.
Synchronizing the Inputs
1 In the DPM Program Entry Setup table, each PE output can be synchronized to
its input according to one of the four output modes. Select the program entry
you want to synchronize and then click Resynchronize or click Resynchronize
All to synchronize the inputs to the outputs according to the service assignments
only. The Confirm Resynchronization window is displayed.
2 Check whether you want to synchronize the PE output according to the services
and then the PIDs assigned to each service, services only, PIDs only, or to
synchronize using a template.
Map Mode
Resynchronize Program, PMT
PID, ES List & ES PIDs
190
Description
The service selected by the Category and Instance will be mapped
to the specified PID. This is only applied if the PE action is Map
and the Remapping Mode is Svc ID & PID.
The service selected by the Category and Instance will be removed
from the PMT and the output stream.
Description
The transcoder will synchronize the PE output according
to the services and then the PIDs assigned to each
service.
OL-31980-01