Cisco D9859 Installation And Configuration Manual page 233

7 From the PSI Table Output Option drop-down list, choose which PSI tables to
include in the program/output stream. The following table describes each
option:
PSI Options
Pass All
Drop All
Ctl By Table
8 From the PSI Regeneration Option drop-down list, choose whether to
regenerate the PSI tables. You can select Always or As Needed (only if t he
content has changed).
9 If Ctl By Table was selected as the PSI Table Output Option, click Table
Options to configure the DPM table options. The DPM Table Options (MOIP)
window is displayed.
10 Choose the tables which will be passed, dropped, regenerated or passed with
rate control (PwRC) from the ASI Output. For more information on the table
options, see PSI Table Settings (on page 105).
The CDT is different from the other tables listed because the CDT is referred to
within the PMT, rather than outside the PMT. Check the Block CDT Output
check box to override the DPM PID map configuration for CDT PIDs and to
always drop all CDTs. Otherwise, uncheck the Block CDT Output to permit the
output of CDTs following the configured DPM PID map configuration and all
other DPM constraints.
OL-31980 -01
Description
Transmits the incoming PSI Tables as is; does not modify the
content and rate.
Does not transmit any PSI Tables.
The operator can click Table Options to select the output mode
for each table. The default table selections will be all pass, and
only with CDT dropped.
Configuring Transport Stream Information
209