Cisco D9859 Installation And Configuration Manual page 288

Chapter 6 Service and Maintenance
Alarm Message
Type
Transcoder Set
Status
Transcoder Set
Status
Transcoder Set
Status
Transcoder Set
Status
264
Message Cause/Remedy
Transcode Not Cause: Possible
Started: FPGA hardware or
failed to load software fault.
Remedy: Clear all
alarms, reset the
unit, and notify
Cisco customer
support if the
problem persists.
Transcode Not Cause: Possible
Started: FPGA hardware or
version mismatch software fault.
Remedy: Clear all
alarms, reset the
unit, and notify
Cisco customer
support if the
problem persists.
Transcode Not Cause: Possible
Started: Decoder hardware or
failed to load software fault.
Remedy: Clear all
alarms, reset the
unit, and notify
Cisco customer
support if the
problem persists.
Transcode Not Cause: Possible
Started: Encoder hardware or
failed to load software fault.
Remedy: Clear all
alarms, reset the
unit, and notify
Cisco customer
support if the
problem persists.
Description Severity
Unable to load Major
or execute the
transcoder
FPGA
software.
Transcoder Major
FPGA software
version does
not match the
hardware
version.
Unable to load Major
or execute the
decoder
software.
Unable to load Major
or execute the
encoder
software.
ID
1500
1500
1500
1500
OL-31980-01