Cisco D9859 Installation And Configuration Manual page 135

Menu Item
SD Bitrate
HD/SD GOP
Control
HD/SD User GOP
(M N)
HD/SD 3:2
Pulldown
SD Aspect Ratio
SD AR Conv
OL-31980 -01
Description
This sets the transcode channel
output bit rate when HD to SD
transcoding is selected for the
output channel.
This selects the Transcode
Group of Pictures (GOP)
format.
This selects the transcode
manual GOP format value. The
transcoder attempts to reuse
information from the encoded
bit stream to improve the video
quality of the transcoded
stream. Amongst others, if the
incoming GOP structure is
similar to that of an MPEG-2, it
will reuse the frame allocations
from the incoming stream as
long as GOP Control is set to I
Frame Sync. If the downstream
transcoder does not support
altering GOP structures, set the
GOP Control setting to User
GOP (MN). This will also
require the setting of the GOP
structure which is given as two
numbers, where the first is the
length of the GOP and the
second is the number of B-
pictures per sub-GOP.
This enables or disables 3:2
pulldown.
This selects the HD/SD
transcode channel aspect ratio.
This selects the HD/SD
transcode channel aspect ratio
conversion. This is the
conversion that the transcoder
will perform on the output
signal for the picture to be
displayed correctly (i.e., to
correspond to the aspect ratio
of your TV) on your TV, based
on your selection.
Parameters
2 to 15 Mb/s in 400 b/s
increments. The default is 4.0
Mb/s.
User GOP (MN), I Frame Sync, or
Fixed GOP
Supported GOP structures - 1 0, 12
2, 15 2, 24 2 or 30 2
Enabled or Disabled
4:3 or 16:9 (wide aspect ratio). The
default is 16:9. Set it to the
corresponding value.
Auto, None, 16:9 L/B (letter box),
4:3 P/B (pillar box), 14:9, 4:3 CCO,
16:9 SCALE or Auto AFD (Auto
setting using Active Format
Descriptor). The default is set to
Auto. See Setup Menu: Services (on
page 76) for more information.
Setup Menu
111