Cisco D9859 Installation And Configuration Manual page 94

Chapter 4 Front Panel Operation
Menu Item
Gateway
Phy Mode
MAC Address
SNMP Read Only
Community String
SNMP Read Write
Community String
70
Description
Sets the Network Gateway Address
on the Network, used to expose the
receiver to a WAN.
Set the speed and duplex type of the
interface. Select Auto for PHY to
negotiate speed and duplex with
other devices on the network, or
select 10 HD (half-duplex), 10 FD
(full-duplex), 100 HD, 100 FD, or 1000
FD to lock into a fixed mode.
Displays the MAC address of the
interface. It is set at the factory and is
a read-only value.
Sets the password to read data from a
device and to display diagnostics
traps/alarms.
This is used when communicating
with a device within an SNMP
environment.
Sets the password to write data to a
device.
This is used when communicating
with a device within an SNMP
environment.
Parameters
The IP Address/Mask and Gateway
Address should be changed together,
i.e., as a group. The following table
shows the most commonly used
Subnet mask values to enter for a
chosen IP address mask, which will
depend on the size of your network.
Mask Subnet Mask
8 255.0.0.0
16 255.255.0.0
24 255.255.255.0
Auto (default), 1000FD (full duplex),
100HD (half duplex), 10FD, 100FD, or
10HD
N/A
Up to 31 alphanumeric characters in
length. This string is case-sensitive.
The default community string is:
public.
Up to 31 alphanumeric characters in
length. This string is case-sensitive.
The default community string is:
public.
OL-31980-01