Cisco D9859 Installation And Configuration Manual page 290

Chapter 6 Service and Maintenance
Alarm Message
Type
Transcoder Set
Verification
Transcoder Set
Verification
Transcoder Set
Verification
TEB State Set
TEB State Set
TEB State Clear
266
Message Cause/Remedy
POST reported Cause: Possible
errors hardware issue.
Remedy: Clear all
alarms, reset the
unit, and notify
Cisco customer
support if the
problem persists.
POST data Cause: Possible
unavailable hardware issue.
Remedy: Clear all
alarms, reset the
unit, and notify
Cisco customer
support if the
problem persists.
Application Cause: Possible
checksum failed hardware issue.
Remedy: Clear all
alarms, reset the
unit, and notify
Cisco customer
support if the
problem persists.
Error state Cause: There is a
transcoder board
error.
Remedy: Clear all
alarms, reset the
unit, and notify
Cisco customer
support if the
problem persists.
TEB Application Cause: There is a
transcoder board
mismatch
error.
Remedy: Clear all
alarms, reset the
unit, and notify
Cisco customer
support if the
problem persists.
Fault cleared –
Description Severity
The transcoder Major
power-on self-
test reported
errors.
The transcoder Major
was unable to
read the results
of the power-
on self-test.
The transcoder Major
software failed
verification.
The transcoder Major
board is in an
error state.
Application Major
version
mismatch
between the
transcoder
board and the
main board.
– Major
ID
1600
1600
1600
2000
2000
2000
OL-31980-01