Cisco D9859 Installation And Configuration Manual page 320

Chapter 6 Service and Maintenance
Alarm Message
Type
FPGA status Set
FPGA status Set
FPGA status Set
FPGA status Set
FPGA status Set
FPGA status Clear
296
Message Cause/Remedy
FPGA Init went Cause: Hardware
LOW (CRC error) issue.
Remedy: Clear
alarms, reset the
unit, notify Cisco
customer support
if the problem
persists.
FPGA Done Cause: Hardware
failed to go high issue.
Remedy: Clear
alarms, reset the
unit, notify Cisco
customer support
if the problem
persists.
SW ver outside Cause: Hardware
upper or lower
issue.
limit
Remedy: Clear
alarms, reset the
unit, notify Cisco
customer support
if the problem
persists.
FPGA ID does Cause: Hardware
not match FPGA
issue.
DESIGNATION
Remedy: Clear
alarms, reset the
unit, notify Cisco
customer support
if the problem
persists.
FPGA ID does Cause: Hardware
not match HW
issue.
FPGA ID
Remedy: Clear
alarms, reset the
unit, notify Cisco
customer support
if the problem
persists.
FPGA loaded –
successfully and
reset
Description Severity
FPGA setup Major
failure or the
FPGA binary
identity does
not match the
FPGA registers.
FPGA setup Major
failure or the
FPGA binary
identity does
not match the
FPGA registers.
FPGA setup Major
failure or the
FPGA binary
identity does
not match the
FPGA registers.
FPGA setup Major
failure or the
FPGA binary
identity does
not match the
FPGA registers.
FPGA setup Major
failure or the
FPGA binary
identity does
not match the
FPGA registers.
– Major
ID
39000
39000
39000
39000
39000
39000
OL-31980-01