Cisco D9859 Installation And Configuration Manual page 98

Chapter 4 Front Panel Operation
Menu Item
Syslog
Syslog Server If Syslog TCP or Syslog UDP is
Port
By enabling or disabling the protocols, dynamic hardware and software firewalls are
created for the D9859 transcoder.
Accessing TCP and UDP Serv ices
The following describes the commands used to access port information for all the supported
protocols. The examples of TCP-based services are: Telnet, SSH, and HTTP. The examples of
UDP-based services are: SNTP and SNMP.
Proceed as follows to obtain TCP or UDP information:
1 Start a new communication session with the receiver using a utility, such as Tera
Term Pro or PuTTY. For more information on starting a new connection, see
Starting a Telnet/SSH Session (on page 30).
74
Description
Select the logging protocol to
use. The Legacy option is used
by Cisco customer support only.
It is highly recommended that
you use the following syslog
servers:
Syslog-ng - Balabit for Linux
Syslog Watcher - SnmpSoft for
Windows
For more information, see
System Logs (on page 222).
selected as the Syslog, set the IP
address of the server.
This sets the TCP or UDP port
number of the server.
Port Number Parameters
Default port Syslog TCP, Disable, Legacy,
#514 for TCP
Syslog UDP
and UDP
N/A 12 digits in length
(###.###.###.###)
N/A 1 to 65535
OL-31980-01