Setting Up Cue Tone Test - Cisco D9859 Installation And Configuration Manual

Setting up Cue Tone Test

1 From the user interface of the D9859, choose Audio & Video > Cue Tone Test.
The Cue Tone Test page is displayed.
2 In the Test Tones field, specify the three digit tone sequence. You can enter a
value between 000 and 999.
3 From the Sequence Mode drop-down list, choose the tone sequence mode. The
following describes the available options:
* - Start tone only
-
# - End tone only
-
*/# - Start and end tones. The end tone is signaled after waiting the time
-
specified in Delay(sec).
4 Click Apply.
OL-31980 -01
Setting up Audio and Video Information
179