Cisco D9859 Installation And Configuration Manual page 117

Menu Item
Config Type
Descramble
Mode
Insert Null
Packet
Auto Map
Auto Map
Aux
OL-31980 -01
Description
Indicates the current DPM
configuration change by a user
after changing the Output Mode.
Select whether the output will be
descrambled if the input is
scrambled.
Select whether to insert null
packets into the output to
maintain output at a constant bit
rate.
Sets whether the DPM resolves
the channel and PID collisions
automatically on the transport
outputs. New values are assigned
to the parameters that caused the
conflict. The new assigned values
are not used by any incoming
transport or other PE outputs. If a
collision is detected, you can
review the new changes before
applying the new changes.
Select whether the DPM sets the
output actions for all the auxiliary
PEs to Map when the Output
Mode is set to Transcode. If the
Fixed Output is set to Yes, the
output configuration for the
auxiliary PEs is determined by
the fixed output table options
when you resynchronize the
output channels and PIDs to
match the input programs.
Note: The DPM resolves any
output conflicts automatically,
even if the Auto Map is set to No.
Parameters
Edited by User - DPM changes were made.
Unmodified - No changes were made after setting
a new Output Mode.
Auto Re-Mapped - Output map changed
automatically to fix the output channel or PID
conflicts at the time of setup.
Changed by Uplink - DPM output changes were
initiated by an encoder.
Scrambled - The output channel will remain
scrambled even if the PE is authorized and can
descramble the channel.
Descrambled - Descrambles the output channel,
and passes in-the-clear channels.
The default is Descrambled.
Yes or No
Note: It is recommended that the Insert Null
Packet is set to Yes, especially if the Output Mode
is set to Transcoding.
Yes or No
Yes or No
Setup Menu
93