Cisco D9859 Installation And Configuration Manual page 130

Chapter 4 Front Panel Operation
Setting
NITO
SDT
SDTO
BAT
EIT
TDT
RST
TOT
DIT
SIT
ECM
EMM
DRT
CDT
Note: The CDT is different from the other tables listed because the CDT is referred to
within the PMT, rather than outside the PMT. Select Pass to permit the output of
CDTs following the configured DPM PID map configuration and all other DPM
constraints. If a DPM PID map has not been configured for the CDT PID and the PE
Act is set to Map, the CDT will still not output. Select Drop to override the DPM PID
map configuration for CDT PIDs and to always drop all CDTs.
Setting Up Digital Program Mapping (DPM)
To set up DPM:
1 Verify that you are receiving a valid signal and that you have set up the channels
that you want to pass, drop or map.
2 Go to the Setup: Outputs, TS Out: DPM: Global menu and select Resync All for
the selected ASI output. This copies the input services PIDs to the remapped
output service PIDs.
3 Go to Setup: Outputs: TS Out: DPM: ASI, and select the PE containing the
channel you want to configure.
4 Set the Act for the selected PMT to either Pass, Drop, XCode, or Map depending
on the action desired. For more information on each mode, see ASI/MOIP1 (see
"ASI/MOIP" on page 100).
106
Mode Options
Pass, Drop, PwRC
Pass, Drop, Regen, PwRC Service Description Table
Pass, Drop, PwRC
Pass, Drop, PwRC
Pass, Drop
Pass, Drop
Pass, Drop
Pass, Drop
Pass, Drop
Pass, Drop
Pass, Drop
Pass, Drop
Pass, Drop
Pass, Drop
Description
Network Information Table -
Other
Service Description Table - Other
Bouquet Association Table
Event Information Table
Time and Date Table
Running Status Table
Time Offset Table
Discontinuity Information Table
Selection Information Table
Entitlement Control Message
Entitlement Management
Message
Disaster Recovery Table
Code Download Table
OL-31980-01