Table of Contents
Advertisement
11 From the Port Selection drop-down list, choose the output mode (None, Control
Port, or Data Port). Choose Control Port to always output data on the
Management port. Choose Data Port to always output data on the Data port.
Choose None to disable the MPEGoIP interface.
12 The IP Version field displays the IP protocol. Only IPv4 is currently supported.
13 Click Apply.
Setting Up the MPEG over IP Auto Synchronization Options
The MoIP Auto Sync area allows you to configure the DPM without editing each
output channel and PID separately.
1
In the MPEG over IP Output page (Transport Stream > MPEG over IP Output),
refer to the MoIP Auto Sync area.
2
From the Enable Auto Fix for Collision drop-down list, choose Yes for the DPM
to resolve channel and PID collisions automatically on the transport outputs.
New values are assigned to the parameters that caused the conflict. The new
assigned values are not used by any incoming transport or other PE outputs. If a
collision is detected, you can review the new changes and click Apply to accept
the new changes.
Choose No and a detailed list of all the conflicts is displayed in the Output
Channel and PID Conflicts table (click View Conflicts) when a conflict occurs.
You can then resolve the conflicts manually.
3
From the Enable Fixed Output drop-down list, choose Yes for the DPM to assign
new values for all the output channels and PIDs according to the Fixed Output
Options table when you Resynchronize All. Click Fixed Output Options to
configure the MoIP Fixed Output Options:
OL-31980 -01
Configuring Transport Stream Information
199
Hide quick links:
Advertisement
Table of Contents
