Cisco D9859 Installation And Configuration Manual page 97

Protocols
The Protocols menu allows you to control remote access protocols (Telnet, SSH, HTTP, and
SNMP) to the IRD.
Menu Item
Telnet
SSH
HTTP
SNMP
MPE
OL-31980 -01
Description
Controls Telnet access to the
IRD.
Controls SSH access to the IRD.
Controls HTTP access to the
IRD.
Controls SNMP access to the
IRD.
Sets whether the MPE data is
forwarded to the network.
Note: The transcoder supports
up to a maximum of 10 Mbps
throughput when forwarding
1500 byte packets.
Port Number Parameters
TCP port #23 Enable (default) - Allow
Telnet connections.
Disable - Disables the listener
for the Telnet port.
TCP port #22 Enable (default) - Allow
secure shell connections.
Disable - Disables the listener
for the SSH port.
TCP port #80 Disable - Disables the listener
for HTTP. for the HTTP port.
TCP port #443 Enable (default) - Allow web
for HTTPS. connections.
Secure - Encrypted access to
the webserver (HTTPS). For
more information, see
Protocol Control Settings (on
page 221).
UDP port Enable (default) - Allow
#161 SNMP connections.
Disable - Disables the listener
for the SNMP port.
N/A Fwd None - The MPE data is
not forwarded to the
network.
Fwd All - All the MPE data is
forwarded to the network.
Fwd Filtered - Only the MPE
data from the defined Static
Multicast Filtering table is
forwarded to the network.
For more information on
configuring the Static
Multicast Filtering table, see
To Add a Static Multicast
Filtering (on page 227).
Setup Menu
73