Cisco D9859 Installation And Configuration Manual page 122

Chapter 4 Front Panel Operation
Menu Item
MOIP
Min IP/s
TOS (Type Of
Service)
TTL (Time To Live)
DestAddr
UDPPort
SrcPort
Send SAP
SAP Multicast
Address
SAP Port
SAP ID
SAP User Str
98
Description
Selects the transport protocol to
be used for the output stream.
This selects the minimum
number of IP packets per
second.
This sets the quality of service.
This sets the hop limit of the
packet's lifespan.
Enter the unicast (valid host IP
only) or multicast destination
IP address.
This selects the destination port
number.
This selects the source UDP
port number.
This selects whether to send
Session Announcement
Protocol messages.
This is the IP address where the
SAP announcements are sent, if
required.
This is the UDP port where the
SAP announcements are sent, if
required.
Describes the SAP output
stream name source.
Provides the SAP user string.
Parameters
RTP or UDP
0, 2 to 1000
0 to 255
0 to 255
Unicast: valid host IP
Multicast: IP in range of 224.0.0.0 to
239.255.255.255
Note: It is not recommended to use
multicast IP addresses reserved by
the Internet Assigned Numbers
Authority (IANA).
1 to 65534
Note: If you selected RTP for MOIP,
you must select an even destination
port number.
Note: It is not recommended to use
destination UDP ports reserved by
the IANA.
0 to 65535
Note: Set the SrcPort to 0 to use the
default source UDP port (49162).
None or RFC2327
It is not recommended to change the
default IP address (224.2.127.54).
1 to 65534
Note: It is not recommended to
change the default SAP port 9875.
User String or SDT Channel
Up to 31 characters
OL-31980-01