Cisco D9859 Installation And Configuration Manual page 147

Backup Channel
Menu Item
PE #
Transport
Backup Channel
Note: We recommend that you configure a minimum of one backup transport. If no backup
transport is configured, an alarm is triggered, but the unit will not be able to switch to a
backup transport.
Backup Transport
Menu Item
Backup
Active
Input, NetId, Freq
(GHz), SymRate,
FEC, Backup,
Modulation, Rolloff
OL-31980 -01
Description
The Program Entry (PE) number you are
configuring the backup transport channel.
The transcoder supports eight program
entries (PE1 to PE8). PE1 is the decode
channel and is available at the analog
outputs. PE2 to PE8 are available for the
transcoded channels on the ASI and MPEG
over IP outputs.
The backup transport number you are
configuring the backup channel.
The backup channel number for the
selected backup transport.
Description
The backup number
Indicates whether the selected backup is
enabled.
To activate a backup, press the ADV key
and press SELECT to insert. The Active
menu for the selected backup number
changes from No to Yes. Press APPLY to
save the changes.
To disable a backup, press the ADV key
and press the RIGHT arrow once and
press SELECT to select Delete. Press the
RIGHT arrow once and press SELECT to
select Continue. The Active menu for the
selected backup number changes from Yes
to No.
For information on the tuning parameters,
see RF1, RF2, RF3, RF4 (RFx) Input (on
page 63).
Note: The RF input must be configured to
match the bandwidth of the backup
parameters.
Setup Menu
Parameters
PE1 to PE8
1, 2, or 3
–
Parameters
1, 2, or 3
Yes or No
–
123