Cisco D9859 Installation And Configuration Manual page 334

Chapter 6 Service and Maintenance
Warning Message
Type
Memory Usage Set
Secondary
Memory Usage Clear
Secondary
FPGA Code Set
Version
FPGA Code Clear
Version
Ethernet Port Set
<n>
Ethernet PHY n Clear
FW: Resource Set
Use Host
310
Message Cause/Remedy
Excessive Cause: Possible software
(stack/partition)
issue.
memory usage
Remedy: Clear
warnings, reset the unit,
and notify Cisco
customer support if the
problem persists.
Normal –
(stack/partition)
memory usage
FPGA newer Cause: FPGA version is
than SW, incompatible with the
Supported=AAA,
software.
Running=BBB
Remedy: Select alternate
FPGA, software
versions, reset unit,
notify Cisco customer
support if problem
persists.
FPGA code ver –
OK
Link is down Cause: No ethernet cable
connected, faulty
cabling, multiple devices
sharing MAC address
on same IP segment, or
possible HW issue.
Remedy: Check cabling,
check MAC addresses,
clear warnings, reset the
unit, and notify Cisco
customer support if the
problem persists.
Connection OK –
Memory or List Cause: Possible software
Near Full issue.
Remedy: Clear
warnings, reset the unit,
and notify Cisco
customer support if the
problem persists.
Description
Software exceeding
allowable memory
usage.
–
FPGA version is
incompatible with
currently operating
software. You may
encounter operational
difficulties
–
Ethernet MAC PHY
device is attempting to
reconnect to external
devices.
–
Software exceeding
allowable usage of
internal constructs.
OL-31980-01
ID
79000
79000
80000
80000
81000
82000
83000
81000
82000
83000
86000