Cisco D9859 Installation And Configuration Manual page 258

Chapter 5 Web GUI Setup and Monitoring
4 From the Enable/Disable drop-down list, choose Yes and the warning message
will be reported. Choose No and the warning is disabled and the Relay and Trap
settings are ignored.
Note: The Enable/Disable drop-down list must be set to Yes for the Relay and
Trap settings to be functional.
5 If current warning is enabled, choose Yes from the Trap drop-down list and the
SNMP trap message will be sent when the warning is set or cleared.
Note: No is a read only value that indicates the setting is Yes, but is currently
being suppressed because the warning is disabled (Enb is set to No).
6 If current warning is enabled, set Relay to Yes for the rear panel alarm relay to
be triggered when the warning is set or cleared.
Note: No is a read only value that indicates the setting is Yes, but is currently
being suppressed because the warning is disabled (Enb is set to No).
7 Click Apply.
234 OL-31980-01