Cisco D9859 Installation And Configuration Manual page 211

ii In the First ES PID Numbers Offset field, enter the offset of the first ES
d From the Use Input PMT ES Stream Order drop-down list, choose Yes to
assign the ES PID according to the incoming PMT order. Otherwise, choose
No to use the reserved PIDs defined below.
i
e Click OK.
4 From the Enable Auto Map For Auxiliary PEs drop-down list, choose Yes for
the DPM to set the output actions for all the Auxiliary PEs to MAP when the
Output Mode is set to Transcode. If the Enable Fixed Table Output is set to Yes,
the output configuration for the auxiliary PEs is determined by the fixed output
table options when you resynchronize the output channels and PIDs to match
the input programs.
Note: The DPM resolves any output conflicts automatically, even if the Enable
Auto Fix for Collision is set to No.
5 Click Apply.
Viewing the ASI Output Status
The ASI Output Status area displays the current Output Rate (0 to 213 Mbps) and
the available bit bandwidth (Free Bandwidth), in Mbps.
OL-31980 -01
PID of subsequent channel numbers. For example, if the First ES PID
Number is set to 101 and the ES PID Numbers Offset is set to 100, then
the first ES PID number is 101, and the second ES PID number is 201.
In the PCR, VID, AUD, SUBT, VBI, DPI, MPE, TTX, DATA, LSD, CDT,
ETV fields, enter the number of PIDs for the specified streams (PCR, VID,
AUD, SUBT, VBI, DPI, MPE, TTX, DATA, LSD, CDT, ETV) in one
channel.
Configuring Transport Stream Information
187