Configuring Transport Stream Information
Configuring the ASI Output
1
From the user interface of the D9824, choose Transport Stream > ASI Output.
The ASI Output page is displayed.
Note: After you make any changes, a successfully updated (session open)
message appears. The changes are displayed, but not saved. You must click
Apply to save and apply the changes.
Note: Any changes made to the ASI DPM values will automatically change the
Mode Status to Edited by User.
2
Choose the output rate control from the Rate Control drop-down list. The
following table describes the affect each of the settings has on the output bit rate:
Configuring Transport Stream Information
207