Table of Contents
Advertisement
Chapter 4 Front Panel Operation
Menu Item
FPGA Version,
Select, Erase
Transcoder Software Versions
The TranscoderSW version parameters list all the software packages used for the
D9859 transcoder. For more information on the software versions, contact Cisco
customer support.
Transcoder Hardware Versions
The following are the version numbers applicable to the Transcoder printed circuit
board.
Menu Item
Transcoder Board Rev Displays the Printed Circuit Board (PCB) revision of the
MCL
MDL
Transcoder
Power Sequencer
FPGA
Transcoder Board SN
128
Description
FPGA Version - Select between all versions of the FPGA code
loaded on the current unit.
Select - Select and then scroll to Yes to reboot the unit and load
the selected FPGA code. You will be prompted to continue or
abort this operation.
Note: Selecting an FPGA code will cause the unit to reboot
and interrupt service.
Erase - Select to erase the selected FPGA code. You will be
prompted continue or abort this operation. You cannot erase
the safe FPGA code or the current FPGA code. While an FPGA
code is being erased, the busy indicator will appear. You
cannot earse another FPGA code until it is complete.
Description
transcoder board.
Indicates the hardware initialization version number for the
transcoder devices on the transcoder board.
Displays the software version number that provides
software access to the transcoder devices.
Displays the version of the firmware performing the
transcode.
Indicates the firmware version running on the power-
sequencer, a chip that controls power-up and power-down
of multiple power supplies.
Indicates the Field Programmable Gate Array (FPGA)
version number.
Indicates the serial number that is uniquely assigned to the
transcoder board.
OL-31980-01
Hide quick links:
Advertisement
Table of Contents
