Cisco D9859 Installation And Configuration Manual page 240

Advanced receiver transcoder
Table of Contents

Advertisement

Chapter 5 Web GUI Setup and Monitoring
5
From the User GOP drop-down list, choose the transcode manual GOP format
value. The transcoder attempts to reuse information from the encoded bit stream
to improve the video quality of the transcoded stream. Amongst others, if the
incoming GOP structure is similar to that of an MPEG-2, it will reuse the frame
allocations from the incoming stream as long as GOP Control is set to I Frame
Sync. If the downstream transcoder does not support altering GOP structures, set
the GOP Control setting to User GOP (MN). This will also require the setting of
the GOP structure which is given as two numbers, where the first is the length of
the GOP and the second is the number of B-pictures per sub-GOP. The
supported GOP structures are 1.0, 12.2, 15.2, 2 4.2 and 30.2.
6
From the 3:2 Pulldown drop-down list, choose Enabled or Disabled to enable or
disable the 3:2 Pulldown.
7
From the Output Aspect Ratio drop-down list, choose the aspect ratio for the SD
transcode output channel. The options are 4:3 and 16:9 (wide aspect ratio). The
default is 4:3. Set it to the corresponding value.
8
From the Aspect Ratio Conversion drop-down list, choose the SD transcode
channel aspect ratio conversion. This is the conversion that the transcoder will
perform on the output signal for the picture to be displayed correctly (i.e., to
correspond to the aspect ratio of your TV) on your TV, based on your selection.
The options are: Auto, None, 16:9 L/B (letter box), 4:3 CCO, 14:9, 4:3 P/B (pillar
box), 16:9 SCALE, or Auto AFD (Auto setting using Active Format Descriptor).
The default is set to Auto.
9
From the Closed Caption Packet 1 and Closed Caption Packet 2 drop-down
lists, choose the order to output the closed caption packets on the transcoded SD
output. The options are None, SCTE-20, or CEA 708.
10 Click OK.
Applying Inband Settings
Note: The Apply Inband Settings is not supported in the current release. You can
apply the inband settings using the front panel. For more information, see Inband
(on page 112).
216
OL-31980-01

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents