Setting Up Cue Tone Test - Cisco D9824 Installation And Configuration Manual

Chapter 5 Web GUI Setup and Monitoring

Setting up Cue Tone Test

1 From the user interface of the D9824, click Audio & Video > Other Outputs,
expand Cueing and then click Cue Tone Test. The Cue Tone Test page is
displayed.
2 In the Test Tones field, specify the three digit tone sequence. You can enter a
value between 000 and 999.
3 In the Sequence Mode drop-down list, select the tone sequence mode. The
following describes the available options:
- * - Start tone only
- # - End tone only
- */# - Start and end tones. The end tone is signaled after waiting the time
specified in Delay(sec).
4 Click Apply.
162 78-4039426-01 Rev D