System Settings - Conductivity - GE AKTA avant User Manual

9.7.2

System settings - Conductivity

The following table describes the conductivity related system settings available for ÄKTA
avant.
Instruction name
Alarm conductivity
Alarm conductivity 2nd
Relative scale cond
Relative scale cond 2nd
ÄKTA avant User Manual 29035184 AE
Description
Enables or disables the conductivity alarm. When en-
abled, it sets the alarm limits for the conductivity signal.
When the conductivity falls outside the set limits, an
alarm will be triggered and the method will be paused.
Enables or disables the conductivity alarm for the sec-
ond conductivity monitor. When enabled, it sets the
alarm limits for the conductivity signal. When the con-
ductivity falls outside the set limits, an alarm will be
triggered and the method will be paused.
Facilitates monitoring of a gradient, for which the user
sets the conductivity values for 0% and 100%. The Rel-
ative scale cond can be set in ascending manner (0%
for low and 100% for high conductivity) or in descending
manner (0% for high and 100% for low conductivity).
Note:
The Relative scale cond in descending manner is espe-
cially useful for conductivity visualization in RPC and HIC,
where the conductivity curve is reversed compared to
the concentration curve (i.e., high conductivity at 0% B
and low conductivity at 100% B).
Facilitates monitoring, using the second conductivity
monitor, of a gradient, for which the user sets the con-
ductivity values for 0% and 100%. The Relative scale
cond can be set in ascending manner (0% for low and
100% for high conductivity) or in descending manner
(0% for high and 100% for low conductivity).
Note:
The Relative scale cond in descending manner is espe-
cially useful for conductivity visualization in RPC and HIC,
where the conductivity curve is reversed compared to
the concentration curve (i.e., high conductivity at 0% B
and low conductivity at 100% B).
9 Reference information
9.7 System settings
9.7.2 System settings - Conductivity
461