Infocenter - Toro 04591 Operator's Manual

1. Parking brake
Parking Brake
Use the parking brake
machine from moving. To engage the parking brake,
push down on the brake pedal and press the top
forward to latch. To release the parking brake, press
the brake pedal until the parking-brake latch retracts.

InfoCenter

Using the InfoCenter LCD Display
The InfoCenter LCD display shows information
about your machine, such as the operating status,
various diagnostics, and other information about the
machine (Figure 22). There is a splash screen, main
information screen, cutting unit (CU) motor information
screen, and traction information screen.
•
Splash screen: shows current machine
information for a few seconds after you move the
key to the O position.
N
•
Main information screen
current machine information while the key is in the
O position. This screen shows the battery-system
N
charge level and the amperage.
1. Battery-system amperage
•
CU motor information screen
shows the speed and current of each cutting-unit
motor.
Figure 18
2. Brake pedal
(Figure 18) to prevent the
(Figure 19): shows
Figure 19
2. Battery-system charge
level
(Figure
1. Front left cutting motor
2. Front right cutting-unit
motor
g236365
•
Traction information screen
shows the current steering angle and the
amperage allotted to each traction motor.
1. Amperage—Front, left
traction motor
2. Amperage—Front, right
traction motor
•
Main menu: refer to
Menu Items (page
Note:
Menus—accessible only by entering PIN;
refer to Accessing Protected Menus (page
You can switch between the main, CU motor, and
traction information screens by pressing the right
button and then selecting the appropriate directional
arrow.
g292768
20):
19
Figure 20
3. Center cutting-unit motor
Figure 21
3. Amperage—Center
traction motor
4. Steering angle
Understanding the InfoCenter
21).
Protected under Protected
g292767
(Figure 21):
g292769
22).