Using The Cutting-Unit Kickstand; Applying The Ce Decals - Toro Reelmaster 5610 Operator's Manual

6
Using the Cutting-Unit
Kickstand
Parts needed for this procedure:
1 Cutting-unit kickstand
Procedure
Whenever you must tip the cutting unit to expose the
bedknife/reel, prop up the rear of the cutting unit with
the kickstand to ensure that the nuts on the back end
of the bedbar adjusting screws are not resting on the
work surface (Figure 36).
Figure 36
1. Cutting-unit kickstand
Secure the kickstand to the chain bracket with the
snapper pin (Figure 37).
7

Applying the CE Decals

Parts needed for this procedure:
1 CE decal
1 Production year decal
1 Warning decal
Applying the CE Decal
g003985
1. Use rubbing alcohol and a clean rag to clean
the area of the hood next to the hood lock, and
allow the hood to dry.
22
Figure 37
(Figure 38).
g004144