Configure Point - Honeywell Vertex M User Manual

ChemCam AutoPicture
When either ChemCam for Level 1 or Level 2 gas is selected, a gas alarm signals the Vertex M
system to store a picture of the stain the next time it advances the Chemcassette™ tape. When
the tape advances, the tape stops with the stain under the camera, the ChemCam takes a
picture and then advance continues. The ChemCam field of view is only wide enough to capture
four points on one picture. See "Optional ChemCam" on page 98 for additional information on
ChemCam features and functions.
Note: This activity will consume additional tape. Some faint stains may not be visible via the
camera.

4.6.5 Configure Point

The Configure Point window provides the following options for each point:
Select the specific target gas
Designate the location of the target gas
Set alarm levels
Enable/disable point
When all of the entries are correct for the point, use either the point selection buttons or choose
Next Point/ Last Point to scroll to the next point in the analyzer. Press Done when all settings
are entered.
Vertex M
Configure concentration logging
Configure point-specific event help
Set PLC full-scale concentration
60 User Manual