Honeywell Vertex M User Manual page 156

3. Open the side of the Analyzer by unscrewing the 4 thumbscrews at the top of the left side.
4. Approximately 20 seconds after the Ethernet Cable has been disconnected, the Analyzer
will recognize that it has lost communications with the DAq and activate the Manual
Override button shown in Figure 7-1. The LEDs on the front of the Analyzer will flash to
show a Maintenance Fault per the LED status flash pattern.
To reset faults and alarms: Press and hold button for 1-3 seconds.
To Put Analyzer into Monitor mode: Press and hold button for 4-9 seconds
To Exit Monitor and Open Gate: Press and hold button for 10 seconds and above
5. Close and reattach the Analyzer cover, reconnect the Ethernet communications cable, and
then slide the Analyzer into the cabinet.
Vertex M
Figure 7-5. Analyzer
Table 7-1. Analyzer Status LEDs
156 User Manual