Setup Menu: Ts Input: Tune Mode: Custom - Cisco PowerVu D9858 Installation And Operation Manual

Setup Menu: TS Input: Tune Mode: Custom

TUNE MODE
CUSTOM
Services List Mode
This menu is where you set up your fixed PID properties (when Tune Mode is Fixed
PID). Select the channel to set up and then edit it.
Description:
Parameters:
Frequency Tuning
Description:
Parameters:
Ch
Description:
Parameters:
Srvc
Description:
Parameters:
4-32 Model D9858 Advanced Receiver Transcoder Installation and Operation Guide
All of the options on this menu allow you to select which tables to
use to obtain tuning and channel lists. The values set on this menu
only apply when Tune Mode is set to Custom.
Degraded or Rigorous. Rigorous means all the default settings
must be present in the received signal. Degraded means only the
table parameters present in the received signal will be used to
install the transcoder. The default is Rigorous.
The following table shows some possible configurations for the
allowed service lists.
Allowed Service Lists
BAT
NIT
SDT
PAT
Frequency Tuning
Sets whether the transcoder is to be tuned to the received signal
using the NIT or a Preset.
NIT or Preset.
This is the channel number.
1 to 16. Use the up and down arrow keys to select the channel to
edit/view. Any changes made will be applied to the displayed
channel only.
This is the service number.
1 to 14. Use the up and down arrow keys to select the service to
edit/view. Any changes made will be applied to the displayed
channel only.
Auto Basic Custom
N N N
Y Y N
Y N N
Y N Y
NIT NIT Preset
Fixed PID
N
N
N
N
Preset
4023074 Rev B