Setup Menu: Outputs - Cisco PowerVu D9858 Installation And Operation Manual

Setup Menu: Outputs

Structure
To view the Outputs menus from the Main menu, press the RIGHT arrow key once
and then the SELECT key to reach the Setup menu. Then press the RIGHT arrow
key four times and the SELECT key to view the Outputs menu.
The Outputs menu allows you to set up the rear panel control relays for alarms, the
transport stream outputs, Digital Program Mapping (DPM) and transcoding.
For instructions on how to select and store settings, see About the Front Panel,
page 4-2.
The Outputs menu has the following structure:
Cueing
Cueing Mode Trigger Polarity
Trigger High
Repeat Tone(ms) Silence(ms)
3 40 40
Seq# State Tones Mode Delay(sec)
16 Disable 999 */# 255
Relay Mode Cue Trigger Bit
Trigger 1
4-48 Model D9858 Advanced Receiver Transcoder Installation and Operation Guide
Main:Setup:Outputs
Cueing TS Out
i s
ASI
i s
Name Rate Control
ASI User
i s
Output Mode
MAP Svc Chans Only
i s
Regenerate Insert Null Packet
As Needed Yes
i s
Main:Setup:Outputs:TS Out
ASI MOIP1 DPM Transcode
User Rate
i s
213.0
Descramble Mode
i s
Descrambled
i s
i s
MOIP1
Name Rate Control User Rate
MOIP1 User 213.0
Output Mode Descramble Mode
MAP Svc Chans Only Descrambled
Regenerate Insert Null Packet
As Needed Yes
Instance Name
MPEG over IP 1
MPEGoIP SAP SAP ID
RTP Yes Channel Name String
v46 DestAddr UDPPort SrcPort
v4 192.131.244.111 12345 12345
TS/IP Min IP/s PCR@IP Start
8 1000000 Yes
SAP MGMT Port Mode DATA Port Mode
Yes Always Output Always Output
SAP Multicast Address PCR Addition
192.131.244.123 Yes
4023074 Rev B
i s
i s
i s
i s
i s
i s
i s
i s
i s