Cisco PowerVu D9858 Installation And Operation Manual page 117

Similarly, an error message will be displayed if the selected settings result in a
PID collision, which indicates that either the selected PID mapping resulted in
the selection of a PID which is being used for another service.
6. Go to Setup: Outputs, TS Out: ASI, and set the Output Mode to Full DPM
Control. Also, if necessary set the Descramble Mode according to whether the
program is to be Scrambled or Descrambled for downstream monitoring.
7. On the same menu, set the following parameters:
Map Mode
Duplic Mode
Unref
PSI Options
PSI Rate
Svc ID
8. Set the table parameters as follows:
PAT
CAT
PMT
TSDT
NIT
NITO
SDT
SDTO
BAT
EIT
TDT
RST
4023074 Rev B Model D9858 Advanced Receiver Transcoder Installation and Operation Guide
Parameter
Parameter
Description
Svc ID & PID
Pkt Copy
Drop
Ctl by Table
Any
Any
Description
Regen
Regen
Regen
Drop
Regen or Drop
Drop
Regen
Drop
Drop
Drop
Pass
Pass
4-65