Setting Up Ts Input And Tuning - Cisco PowerVu D9858 Installation And Operation Manual

Setting Up TS Input and Tuning

Proceed as follows to set up the TS Input and Tuning:
1. Press the MENU key and use the
Input: Input menu, using the SELECT key to move down each level, and then
use the
Convention, page 4-4 for instructions on the use of the front panel keypad
buttons, and the Main Menu, page 4-10 for information on the front panel menu
structure.
RF1 or ASI
LO1, LO2, Xover
Input
Modulation
Freq. Sym Rate and FEC
Set LNB Voltage
Rolloff
Net ID
2. Press MENU to exit the menu level and save the changes.
Note: If the changes are saved successfully, the transcoder will return to the
Main Menu. It will search for the signal and display "Acquisition Successful".
The transcoder will find the first available channel on the network. You can
select another available channel if necessary. If when entering parameters, the
changes cannot be saved successfully, a "Value out of range" or "Invalid
Parameters!" error message appears and you will need to continue editing.
Select 'Yes' to continue editing. If 'No' is selected, all the changes will be lost.
1-4 Model D9858 Advanced Receiver Transcoder Installation and Operation Guide
arrow keys to set the following parameters. See Keypad
Entry/Selection
arrw keys to navigate to the Setup: TS
Options
Set to ACT to enable/activate the input.
Note: It is not necessary to set the
tuning parameters if you are using the
ASI input.
LO (Local Oscillator) and Crossover
frequencies in GHz.
4 RF input ports to select.
DVB-S or DVB-S2. If set to DVB-S2, set
FEC to Auto.
Type in downlink frequency (in GHz)
If the FEC is unknown, leave it at
"Auto". It must be set to Auto if DVB-S2
modulation is used.
Only RF1 has DC power.
LNB Voltage options - 13 (V), 18 (V)
and Off.
Only required for DVB-S2.
Enter your network ID.
4023074 Rev B