Dpm Default Settings For Different Output Modes - Cisco PowerVu D9858 Installation And Operation Manual

DPM Default Settings for Different Output Modes

The DPM parameters are preset to default settings for each DPM Output Mode.
The default settings for particular Output modes have been preset to optimize the
output when either PID mapping or transcoding is required. If the DPM parameters
are changed to values which switch the transcoder to Full DPM Control, the
transcoder may enter a condition where conflicts in the settings may occur, which
may require manual manipulation of the DPM or output parameters to obtain the
desired output.
If you change any of the DPM parameters listed in this table in any of MAP and
Transcoding Output Modes, the transcoder Output Mode will change to DPM Full
Control, but will retain the current settings. This is noted in the table below.
Full DPM Control with DPM
MAP Pass Through
MAP Svc Chans Only
Transcoding
4023074 Rev B Model D9858 Advanced Receiver Transcoder Installation and Operation Guide
Output Mode Changes to
Parameter Change
No Output Mode Change with DPM
Parameter Change
No Output
Passthrough
Service Chans Only
B-9