Cisco PowerVu D9858 Installation And Operation Manual page 157

Warning
Memory Usage
Memory Usage
FPGA Code Version Set
Ethernet PHY #
FW: Resource Use
HOST
4023074 Rev B Model D9858 Advanced Receiver Transcoder Installation and Operation Guide
Message Message
Type
Set Excessive (stack/
partition) memory
usage
Clear Normal (stack/
partition) memory
usage
Set Excessive (stack/
partition) memory
usage
Clear Normal (stack/
partition) memory
usage
FPGA code version
mismatch:
format(Rel.Maj.Min.
Nan),
Required=#.#.#.#,
Running=#.#.#.#
Clear FPGA code ver OK
Created fault but not
used.
Set Memory or List Near
Full
Clear Normal Level
Cause/Remedy
Cause: Possible software
issue.
Remedy: Clear warnings,
reset unit, and notify
customer service if problem
persists.
Cause: Possible software
issue.
Remedy: Clear warnings,
reset unit, and notify
customer service if problem
persists.
Cause: Possible HW Issue.
Remedy: Clear warnings,
reset unit, and notify
customer service if problem
persists.
Cause: No ethernet cable
connected, faulty cabling,
multiple devices sharing
MAC address on same IP
segment, or possible HW
issue.
Remedy: Check cabling,
check MAC addresses,
clear warnings, reset unit,
and notify customer service
if problem persists.
Cause: Possible software
issue.
Remedy: Clear warnings,
reset unit, and notify
customer service if problem
persists.
Description
SW exceeding
allowable memory
usage.
SW exceeding
allowable memory
usage.
FPGA binary identity
does not match FPGA
registers.
Ethernet MAC PHY
device is attempting
to reconnect to
external devices.
SW exceeding
allowable usage of
internal constructs.
5-17