Cisco PowerVu D9858 Installation And Operation Manual page 105

Setup Menu: Outputs: TS Out: MOIP1,
Output Mode
Description:
Parameters:
Output Mode
No Output
Passthrough
Service Channels
Only
MAP Passthrough
MAP Svc Chans
Only
Full DPM Control
Transcoding
Note: If you change any of the DPM parameters while in MAP Passthough, MAP
Svc Chans Only or Transcoding Output Modes, the Output Mode will change to
Full DPM Control. Full DPM Control is primarily used for manual control, but uses
the last set of DPM settings prior to changing the mode.
Note: When changing any DPM parameter in either MAP Passthough, MAP Svc
Chans or Transcoding Output Modes, you will prompted with a "Resync All"
message. If you choose No, the transcoder will use the current settings in which
case, if the PMT content has been changed, the input to output PID mapping will be
lost; however, if you choose Yes, the transcoder will use the new PMT content.
4023074 Rev B Model D9858 Advanced Receiver Transcoder Installation and Operation Guide
Continued
This selects the DPM output mode.
No Output, Passthrough, Service Channels Only, MAP
Passthrough, MAP Svc Chans Only or Full DPM Control. These
settings are described in the table below.
No ASI or MPEGoIP output will be generated.
The output will be identical to the input. The output
channel will not be modified.
PE/PID remapping options, PSI regeneration and User
Rate are not supported in this mode.
Only service channels will be output.
The output will be identical to the input, except that it
will be generated using the DPM and PID mapping
settings.
Only service channels will be output according to the
DPM and PID mapping settings.
The output will be generated according to the DPM
settings on the DPM: ASI or MOIP1 menus. This is a
manual control setting.
The output will be generated using the DPM default
settings, except that the DPM action (Act) will be set to
Xcode and the Descramble Mode will be set to
Descrambled.
Description
4-53