Messages - Cisco PowerVu D9858 Installation And Operation Manual

Messages

General
The status of the D9858 Advanced Receiver Transcoder and its immediate
surroundings is reported to the front panel in the form of messages and alarms. You
can enable or disable messages in the Alarm/Warning settings.
D9858 Advanced Receiver Transcoder Message List
The following table shows an alphabetical list of the available messages and their
default alarm status. The Set Messages and Clear Messages are displayed in the
Warning History when the messages are set or cleared respectively.
Note: Only alarm conditions can be used to trigger rear panel relays to control
external alarm equipment. Warnings are not associated with relay operation.
Alarms
Alarm Message
Type
Signal Status Set
Clear
5-4 Model D9858 Advanced Receiver Transcoder Installation and Operation Guide
Message
ASI Signal - No
Content
Signal is lost
Signal is locked
Cause/Remedy
Cause: Loss of RF
external to IRD.
Remedy: Check RF
settings.
Description Severity
Loss of Signal Minor
4023074 Rev B