Front Panel Setup - Cisco PowerVu D9858 Installation And Operation Manual

Front Panel Setup

Locking/Unlocking the Front Panel
The front panel can be locked or unlocked using the front panel keypad.
Proceed as follows to unlock the front panel using the front panel keypad:
1. When at the Main Menu, press SELECT and then INFO. This will unlock the
front panel keypad and allow you make changes to all the operating parameters;
however, if the keypad remains untouched for the duration of the set timeout
period (default is 60 seconds), the keypad will change back to the Lock state
unless you change the keypad state on the Admin Menu. Likewise you toggle
the keypad lock state back using SELECT and INFO at any time provided the
KB Lock state on the Admin Menu is Enabled. See Keypad Convention,
page 4-4 for instructions on the use of the front panel keypad buttons
2. To disable Lock completely, navigate to Setup: Admin: KB Lock in the LCD
display and press the SELECT key.
3. Change the KB Lock state from Enabled to Disabled.
4. The front panel will now be unlocked allowing you to change any of the
operating parameters.
To lock the front panel, perform the same procedure, except use the
change the state. You will not be prompted to confirm the operation.
4023074 Rev B D9858 Advanced Receiver Transcoder Installation and Operation Guide
key to
1-3