Cisco PowerVu D9858 Installation And Operation Manual page 28

Connecting the Unit,
Connecting Power Cables
6. Connect the power cord (supplied with the unit) between the rear panel power
receptacle and a 100V to 240V, 50/60 Hz AC power outlet.
The power cord (consisting of appliance coupler, flexible cord, and plug)
supplied with this product meets the requirements for use in the country for
which this product was purchased. In general, the power cord must be
approved by an acceptable, accredited agency responsible for evaluation in the
country where the product will be used.
When connecting the power source to the D9858 transcoder, it takes less than a
minute for the unit to initialize. The front panel display displays the startup
screen.
Maintenance of EMC Compliance
Double-shielded (braid/foil or braid/braid) cables should be used for all ASI I/O
and RF inputs. Single-shield cables are acceptable for all other inputs and outputs.
For terminal block (Alarms) I/O, no shielding is required.
1-2 Model D9858 Advanced Receiver Transcoder Installation and Operation Guide
Continued
4023074 Rev B