Input/Output Settings - Cisco PowerVu D9858 Installation And Operation Manual

Input/Output Settings

Proceed as follows to configure the Video output format and TS Output settings:
1. Press the MENU key and use the RIGHT arrow key to navigate to the Setup:
Services: Video menu, using the SELECT key to move down each level, and
then use the
Entry/Selection
SD Format
2. Press MENU to exit the menu level and save the changes.
3. Use the
menu, using the SELECT key to move down each level, and then use the
Default Settings for Different Output Modes, page B-9 for information on the
default settings for each output mode, to choose the desired Output Mode.
Entry/Selection
Output Mode
Resync All
4. Press MENU to exit the menu level and save the changes.
1-6 Model D9858 Advanced Receiver Transcoder Installation and Operation Guide
arrow keys to navigate and set the video output format.
Set to Auto (default) or the particular output resolution
for the monitor, e.g., NTSC or PAL.
arrow key to move to the Setup: Outputs: TS Out: ASI or MOIP1
arrow keys to navigate and configure the Output Mode. Refer to DPM
It is recommended to set the Output Mode to
Transcoding. The output mode is factory set to No
Output as the default.
Resynchronize the output services, ASI or MOIP1.
Select Yes when prompted.
Options
Options
4023074 Rev B