Connecting The Rs-232 Data Interface - Cisco PowerVu D9858 Installation And Operation Manual

Connecting the RS-232 Data Interface

The RS-232 Data Interface
The DCE DB-9 female connector is intended for low-speed data: 7 bits, even parity,
1 stop bit, up to 38.4 kbps (default). These outputs are user-configurable via the
Setup Menu on the front panel.
The interconnect cable from the D9858 transcoder to a PC should be straight
through (i.e., no handshaking), shielded and equipped with a DB-9 male connector
at one end to mate with the rear panel RS-232 Data interface, and a female DB-9
connector to connect to the PC.
Pin Allocation, RS-232 Data Connector
The table shows the RS-232 Data connector and the pin allocation
Connector
9
3-14 Model D9858 Advanced Receiver Transcoder Installation and Operation Guide
Pin
1 Not connected
1
2 TxD
3 RxD
4 Not connected
5 Ground
6 Not connected
7 Not connected
8 Not connected
9 Not connected
Pin allocation
:
4023074 Rev B