Section C - Connecting The Input/Output Signals; Connecting The Rf Inputs; Connecting The Asi Input - Cisco PowerVu D9858 Installation And Operation Manual

Section C - Connecting the Input/Output Signals

Connecting the RF Inputs

Do as follows to connect to the RF inputs:
1. Connect up to four LNB RF cables to the RF connectors labelled RF1 through
RF4 on the rear of the unit.
Use 75-ohm (braid/foil or braid/braid), low insertion loss coaxial cable.
Each input accepts an LNB signal input. RF2 to RF4 require an external LNB
power source.

Connecting the ASI Input

Do as follows to connect to the ASI input:
1. If desired, connect to the ASI IN port to an asynchronous serial interface for
uplink monitoring.
4023074 Rev B Model D9858 Advanced Receiver Transcoder Installation and Operation Guide 3-7