Chapter 1 Quick Setup - Read Me First; Connecting The Transcoder - Cisco PowerVu D9858 Installation And Operation Manual

Connecting the Transcoder

Proceed as follows to connect the Model D9858 Advanced Receiver Transcoder to
other equipment.
MOPEG
1. Connect the L-Band signal to RF1.
Note that LNB power is only available on the RF1 port. RF2 to RF4 require an
external LNB power source. The factory default setting for LNB power is OFF.
2. If desired, connect the ASI IN port to an asynchronous serial interface device for
uplink monitoring.
3. Connect the ASI OUT ports to an asynchronous serial interface device for digital
tier applications.
Important! A double-shielded coaxial cable is required to connect to the ASI
OUT and/or the ASI IN port in order to meet EMC requirements.
4. Connect the Composite Video Outputs to a video monitor.
5. Using a multi-conductor, pluggable cable, connect the transcoder's balanced
audio outputs, terminal blocks AUDIO 1 and AUDIO 2 to monitoring
equipment.
Note: The Ethernet MANAGEMENT port does not currently provide SNMP or
management control. It is used for software application downloads only.
4023074 Rev B Model D9858 Advanced Receiver Transcoder Installation and Operation Guide
Chapter 1
Quick Setup - Read Me First!
1-1