Cisco PowerVu D9858 Installation And Operation Manual page 116

Setup Menu: Outputs: TS Out: DPM,
PE Resync: All, Template, PIDs, Svcs
Description:
Parameters:
Setting Up Digital Program Mapping (DPM)
To set up DPM:
1. Verify that you are receiving a valid signal and that you have set up the
channels that you want to pass, drop or map.
2. Go to TS Out: Outputs: DPM and set Resync to All to resynchronize the inputs
to the outputs of the current PMT according to the service assignments and then
the PIDs for the two program entries.
Note: It is recommended that you use the Resync function to synchronize the
programs and not manually modify the output. You should only change the
settings if you fully understand your downstream setup.
3. Go to Setup: Outputs: TS Out: ASI and select the PE containing the channel that
you want to configure.
4. Set the ACT for the selected PMT to either Pass, Drop, Map or XCode
depending on the action desired.
5. Use the RIGHT arrow key to move to the right and select PID to display the
detailed menu level. Configure the input to output channel mapping. Video and
PCR can be output on the same PID or different PIDs. If output on the same PID,
they will appear identical to the input. The example below shows the PMT
passed but the services PIDs remapped.
Note: If the parameters cannot be saved, the problem may be that the incorrect
Map Mode has been selected. Ensure that Svc ID & PID is selected when
remapping PIDs, otherwise a message such as "Bad configuration data" will be
displayed and you will need to change the parameters to obtain the correct
output.
4-64 Model D9858 Advanced Receiver Transcoder Installation and Operation Guide
Continued
Each PE output can be synchronized to its input according to one of
four output modes.
Services only (Svcs), PIDS only (PIDs), using a Template or All
(Services and PIDS).
TS Out: DPM: ASI
PE InCh PMT Act
PE1 205 5001 Xcode 204
Change Action
InTyp In PID
VID 4 2001 Map
PID remapped
OutCh PMT PID
i s
5001
Act OutType In PID
VID 4 2004
i s
4023074 Rev B