Setup Menu: Outputs: Ts Out: Asi, Continued - Cisco PowerVu D9858 Installation And Operation Manual

Setup Menu: Outputs: TS Out: ASI,
User Rate
Description:
Parameters:
Output Mode
Description:
Parameters:
Output Mode
No Output
Passthrough
Service Channels
Only
MAP Passthrough
MAP Svc Chans
Only
Full DPM Control
Transcoding
4-50 Model D9858 Advanced Receiver Transcoder Installation and Operation Guide
Continued
This parameter controls the output rate. It is only used if Rate
Control is set to User. This setting is used when the signal source is
RF or ASI. Note that output data may be lost when the user-selected
bit rate is set to a value that is less than the actual signal bit rate.
This allows you to set the output bit rate to a value expected by
equipment connected to the ASI output.
0 to 213 Mbps.
This selects the DPM output mode.
No Output, Passthrough, Service Channels Only, MAP
Passthrough, MAP Svc Chans Only, Full DPM Control or
Transcoding. These settings are described in the table below.
No ASI or MPEGoIP output will be generated.
The output will be identical to the input. The output
channel will not be modified.
PE/PID remapping options, PSI regeneration and User
Rate are not supported in this mode.
Only service channels will be output.
The output will be identical to the input, except that it
will be generated using the DPM and PID mapping
settings.
Only service channels will be output according to the
DPM and PID mapping settings.
The output will be generated according to the DPM
settings on the DPM: ASI or MOIP1 menus. This is a
manual control setting.
The output will be generated using the DPM default
settings, except that the DPM action (Act) will be set to
Xcode and the Descramble Mode will be set to
Descrambled.
Description
4023074 Rev B