Philips Sopho 2000 IPS User Manual page 834

A
CM35 Specify the type of answer signal from distant
office in outgoing connection for each trunk
route.
Provide SMDR service for outgoing calls to re-
quired trunk routes.
Assign a trunk access code for SMDR.
CM41 Specify the timing of SMDR valid call timer
(pseudo-answer timer).
CMD000 Send message to PMS, if a checked out station
is originating a C.O. call.
CMD015 Assign the charging Service Class number to
each station number, if PMS with AP00 on RS-
232C is provided.
CMD016 Send detail call information on outgoing calls
to SMDR, if PMS with AP00 on RS-232C is
provided.
CMD026 Assign the Development Table number to out-
going trunk routes, if PMS with AP00 on RS-
232C is provided.
B
DESCRIPTION
HOTEL SYSTEM PROGRAMMING
• Y=04
(1) 00-63: Trunk Route No.
(2) 1 : Battery Reversal from C.O. line
2 : Answer signal arrives from Tie Line/
ISDN
7 : Answer signal does not arrive
• Y=14
(1) 00-63: Trunk Route No.
(2) 1 : To provide
• Y=44
(1) 00-63: Trunk Route No.
(2) 00-99: Trunk Access Code
• Y=0
(1) 03
(2) 01-08: 4-40 seconds
If no data is set, the default setting is 20-24 sec-
onds.
(1) 88
(2) 0 : Not sent
1 : To send
(1) X-XXXX: Station No.
(2) 00 -15: Service Class No.
(1) XX 16
XX: Service Class No. assigned by
CMD015
(2) 1: To send
(1) 00-63: Trunk Route No.
(2) 000 -511: Development Table No.
– 816 –
MESSAGE REGISTRATION
DATA
(4 second increments)
NWA-008845-001 Rev.5.0
NOVEMBER/15/2006
32ch2001.fm