Philips Sopho 2000 IPS User Manual page 118

To provide an external Call Waiting Indicator:
START
CM08 Assign the incoming call to queuing mode
when all ACD stations are busy.
CM42 Specify the maximum number of queuing in
each ACD group for controlling external indi-
cator lamp.
NOTE:
N=Number of queuing station/trunk
2nd Data=01
N<2nd Data (2nd Data≠01)
2nd Data≤N (2nd Data≠01)
CM10 Assign the DK card to the required LEN.
NOTE 1:
CM14 Assign the DK card to the required LEN.
[Series 3200 R6.2 software required]
NOTE 1:
A
DESCRIPTION
Depending on the number of queuing station/trunk, lamp indication pattern on the external
indicator is different as shown below:
CONDITIONS
The DK card number must be
assigned to the first LEN (Level 0)
and the third LEN (Level 2) of each
LT slot.
The DK card number must be
assigned to the first LEN (Level 0)
and the third LEN (Level 2) of each
LT slot.
AUTOMATIC CALL DISTRIBUTION (ACD)
(1) 212
(2) 1 : Queuing
(1) 15
(2) 01-99
NONE : 1 call
LAMP INDICATION
Lamp on irrespective of number of queuing station/trunk (For the
indication pattern, see CM59 in next page.)
Lamp off
Lamp on (For the indication pattern, see CM59 in next page.)
(1) 000-763: LEN
(2) E800-E831 : DK card No.
For PIM0/1: E800-E807
For PIM2/3: E808-E815
For PIM4/5: E816-E823
For PIM6/7: E824-E831
NOTE 2:
(1) XX ZZZ: LEN
XX : 00-59: FP No.
ZZZ: 000-127: Port No.
(2) E800-E831
For FP No. 00 : E800-E807
For FP No. 01 : E808-E815
For FP No. 02 : E816-E823
For FP No. 03 : E824-E831
NOTE 2:
– 100 –
CALL WAITING INDICATION-ACD
DATA
: 1 call-99 calls
Circuit No. 3 of E831 is used for
built-in External Equipment Interface
on MP card by setting CM44.
: DK card No.
Circuit No. 3 of E831 is used for
built-in External Equipment Interface
on MP card by setting CM44.
NWA-008845-001 Rev.5.0
32ch1002.fm